Hasselblad V10 Instruction Manual download pdf (Page 23)

General points and tips

•  Beforeyoucanmakeanexposure,youmustremovethemagazineslide.Themaga-

zine will then be locked on the camera body, and the camera release button will be

unblocked.

•  Filmisautomaticallyadvancedinthemagazineafterafullturnofthecrank.

•  Youcannotremovealmmagazinewithoutre-insertingthemagazinesliderst.

•  Donotattachamagazineshowingredtoafullywoundcamera!Thiscouldresultin

a double exposure.

•  Themagazine’slmwindingcrankisonlyblockedatframe1.Apartiallyexposedlm

may be wound oﬀ at any frame afterwards.

•  Ontherearofthemagazineisaslidepocketwherethemagazinedarkslidecanbe

kept when not in use. Turn the slide with the hinge towards the rear to fold the bow

fully into the slide pocket recesses.

•  Donotputthelmholderdownonanuncleansurfaceorwhereitcanattractdust.

•  Cleanoutthemagazinehousingregularlyremovingnotonlydustandparticlesbut

also any scraps of paper from previous rolls that may have remained inside.

•  Eachmagazinehousingandlmholderformacarefullymatchedpair.Becareful,

therefore, when loading more than one magazine at a time not to switch housings

and holders. The last three ﬁgures of the housing serial number should correspond

with the serial number on the ﬁlm holder.

•  Loadandunloadthemagazineawayfromdirectlightsources.

•  Ifyoukeeptheslideinsertedinanattachedmagazine,itwillactasanexposurelock

to prevent inadvertent exposures when the camera and shutter have been wound on.

•  AlignthearrowonthepaperbackingofallIlfordblack&whitelmsagainsttheoblong

index (and no further) on the spool clamp bar and not the triangular index as normal.

Using infrared ﬁlm

Infrared (IR) rays (wavelengths longer than 800 nm) form an image on a plane further away

from the lens than the image plane for visible light. To compensate for this diﬀerence you

have to align the chosen distance against the red IR index and not the normal central index.

Proceed as follows:

1. Focus as usual on the focusing screen.

2. Note the distance on the focusing scale that is opposite the central index line.

3. Now rotate the focusing ring to set this distance opposite the dashed IR index line

instead of the central index line.

Note

Please observe the special information

that came with your IR ﬁlm about restric-

tions concerning magazine loading, ﬁlm

development, etc.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 91 92

No comments

Hasselblad V10 Instruction Manual Page 23